I believe everyone is familiar with the flush toilet. It is an indispensable and important equipment in our bathroom. How to install the flush toilet? Does anyone know? The following editor will introduce you in detail how to install a flush toilet.
Preparation before installing the flush toilet
1. Check the level of the floor where the toilet is to be installed. If it is found to be tilted, it can only be installed after it is adjusted to a level;
2. Check the toilet's sewage pipe before installation to remove sediment, waste paper and other debris in the sewage pipe;
3. The drain outlet should be kept 2-5 mm above the ground;
4. After debugging and installing the water tank accessories, turn on the tap water, fill the water tank with water, and then observe for a few minutes whether there is any leakage in the water tank or the water inlet hose;
5. The water pressure of tap water is generally relatively stable after the water tank is filled with water. Test the toilet's sewage discharge effect and whether the flush is powerful. If the water vortex is very strong and rushes very fast, it means that the water is flowing smoothly. On the contrary, check whether there is any blockage.
How to install a flush toilet
1. Fixed toilet
Method 1: Pull-out bolt fixing method. This method is for toilets designed with mounting holes at the bottom. Place the toilet on the installedIn terms of location, use a pencil to draw the location and bottom outline of the hole to be made on the ground according to the location of the installation hole. Then remove the toilet, make a hole at the marked location and insert the explosion-receiving bolt, and drain the waste between the toilet outlet and the ground. Apply adhesive to the joint, place the toilet smoothly, pull out the bolts firmly, and finally seal the toilet feet with cement mortar.
Method 2: Cement bonding method, this method is for toilets designed without mounting holes at the bottom. Place the toilet in the installation position, use a pencil to draw the outline of the bottom of the toilet, lay a circle of cement mortar 30mm wide and 15mm high inward along the outline, and apply adhesive at the joint between the toilet outlet and the ground sewage outlet. , wipe clean the feet of the toilet, place it smoothly in the installation position, make it firmly bonded, and wipe away the overflowing cement mortar.
2. After completing the fixation of the toilet, immediately wipe off the excess cement adhered to the toilet and the floor;
3. Connect the toilet tank and water pipe;
4. Check whether there is leakage in the water tank, and then flush the water to check whether the sewage pipe is smooth;
5. It cannot be used for three days after installation. At the current cement solidification speed, it will take at least one day without use, so as not to affect its stability.
